Vlan - Revision history

WFilter at 14:23, 21 June 2017

2017-06-21T14:23:43Z

2016-06-23T06:21:27Z

2016-05-25T05:51:29Z

Created page with "{{DISPLAYTITLE:VLAN}}"

New page

@@ Line 3: / Line 3: @@
 = Introduction =
-"VLAN module" can add "802.1Q VLAN" support for LAN interfaces of WFilterROS. Usually, you can add VLANs by below two solutions:
+"VLAN module" can add "802.1Q VLAN" support for LAN interfaces of WFilter NGF. Usually, you can add VLANs by below two solutions:
-* Add LAN interfaces in "Interfaces" of WFilterROS, and assign different subnets to LAN interfaces. This is a simplest solution(similar to port-based VLAN).
+* Add LAN interfaces in "Interfaces" of WFilterNGF, and assign different subnets to LAN interfaces. This is a simplest solution(similar to port-based VLAN).
 * Setup VLAN in your core three-layer switch.
-** Core switch is connected to WFilterROS via an "access port". With this connection type, you don't need to configure VLAN in WFilterROS.
+** Core switch is connected to WFilterNGF via an "access port". With this connection type, you don't need to configure VLAN in WFilterNGF.
-** Core switch is connected to WFilterROS via a "trunk port". With this type, you need to create VLANs in the WFilterROS "VLan" for the target VLANs to access internet.
+** Core switch is connected to WFilterNGF via a "trunk port". With this type, you need to create VLANs in the WFilterNGF "VLan" for the target VLANs to access internet.
 = Settings =

← Older revision		Revision as of 06:21, 23 June 2016
Line 1:		Line 1:
	{{DISPLAYTITLE:VLAN}}		{{DISPLAYTITLE:VLAN}}
		+
		+	= Introduction =
		+
		+	"VLAN module" can add "802.1Q VLAN" support for LAN interfaces of WFilterROS. Usually, you can add VLANs by below two solutions:
		+
		+	* Add LAN interfaces in "Interfaces" of WFilterROS, and assign different subnets to LAN interfaces. This is a simplest solution(similar to port-based VLAN).
		+	* Setup VLAN in your core three-layer switch.
		+	** Core switch is connected to WFilterROS via an "access port". With this connection type, you don't need to configure VLAN in WFilterROS.
		+	** Core switch is connected to WFilterROS via a "trunk port". With this type, you need to create VLANs in the WFilterROS "VLan" for the target VLANs to access internet.
		+
		+	= Settings =
		+
		+	You can add multiple VLANs in each LAN interfaces.
		+
		+	[[File: vlan01.png\|600px]]
		+
		+
		+	[[File: vlan02.png\|900px]]
		+
		+
		+	[[Category:Network]]