1 Introduction

"VLAN module" can add "802.1Q VLAN" support for LAN interfaces of WFilterROS. Usually, you can add VLANs by below two solutions:

Add LAN interfaces in "Interfaces" of WFilterROS, and assign different subnets to LAN interfaces. This is a simplest solution(similar to port-based VLAN).
Setup VLAN in your core three-layer switch.
- Core switch is connected to WFilterROS via an "access port". With this connection type, you don't need to configure VLAN in WFilterROS.
- Core switch is connected to WFilterROS via a "trunk port". With this type, you need to create VLANs in the WFilterROS "VLan" for the target VLANs to access internet.

2 Settings

You can add multiple VLANs in each LAN interfaces.