IPSec Tunnels

1 IPSec Tunnels

This modules can build IPSec tunnels between multiple WFilter NGF networks, and make a secure site-to-site VPN. The number of IPSec Tunnels depends on your hardware performance, there is no software limit on the tunnels number.

2 IPSec Tunnel Settings

Before you setup a IPSec tunnel, you need to design your tunnels. For example:

• Suppose you have 3 network: A, B, C.
• A has a static public IP, B and C ip addresses are dynamic.

The solution will be:

• A, B, C shall have differenct subnets. For example: 192.168.10.x, 192.168.20.x, 172.16.1.x.
• Create a tunnel in A network, set "Remote IP" to "Any".
• Create tunnels in B and C networks, set "Remote IP" to A's public ip address.
• Now the tunnels are ready. A, B, C now are in a VPN network. The tunnels are between AB and AC.
• To enable access between B and C, you need to setup routering rules and enable FORWARD in A.

Description of tunnel settings:

• Name: tunnel name.
• Interface: WAN interface to setup the tunnel.
• Local Subnet: local subnet to be connected with the tunnel.
• Remote Site: another side of the tunnel, "Any" to allow any others to connect. The remote site can be an IP address or domain.
• Remote Subnet: remote LAN subnets which will be forwarded to the tunnel.
• PreShared Key: tunnel secret key. With a correct key, the tunnel can not be established.
• Start: Manually or Automatically.
• IKE, ESP: algorithm for authentication and transfer. Both sides of the tunnel shall have the same algorithm.

Server side settings examples:

Client side settings examples:

Notice:

• Access of tunnels are also applied with firewall rules. For example, if you want to block VPN tunnels users from accessing a local server, you need to setup a firewall rule to block the target server ip from WAN interface.
• If you enable DMZ or "Static NAT", please add IPSec port "500,4500" to "port exception". Otherwise, IPSec connections can not be established.
• If the WAN interface has multiple static ip addresses, IPSec only listens in the first IP address.

3 Tunnel Status

Move your mouse into the "state" icon, you will see the tunnel status and connected clients.

4 A site to site ipsec vpn sample

Suppose you have 3 networks:

• Headquarter A, static public ip address, LAN subnet is 192.168.10.0/24.
• Branch B, PPPoE internet access, LAN subnet is 192.168.30.0/24.
• Branch C, PPPoE internet access, LAN subnet is 172.16.1.0/24.

Now let me guide you to build a virtual private network(VPN) for these three locations.

4.1 Settings for Headquarter A

• Setup the IPSec tunnel

• Enable forwarding of branches

Without this setting, branches can access headquarter, but no access between branches.

4.2 Branch B

• Setup the IPSec tunnel

• Add a routing rule to branch C

Set branch C's LAN subnet to "Destination", set headquarter A's public IP to "Gateway". Without this routing rule, branch B can not access branch C.

4.3 Branch C

• Setup the IPSec tunnel

• Add a routing rule to branch B

Set branch B's LAN subnet to "Destination", set headquarter A's public IP to "Gateway". Without this routing rule, branch C can not access branch B.

By above steps, A,B,C are now in a virtual private network. If you don't want access between B and C, there is no need to add the firewall and routing rules.