Forwarding, DMZ and Static NAT

From Wiki of WFilter NG Firewall
Revision as of 16:00, 6 May 2022 by WFilter (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search


Contents

1 Introduction

"Port Forwarding", "DMZ" and "Static NAT" are all redirecting firewall rules.

  • "Port Forwarding" : forword packets on certain port(s).
  • "DMZ" equals "port forwarding on all ports". Visits to WAN interfaces will be redirected to the DMZ host(except of the excepted ports).
  • "Static NAT" provides one-to-one NAT for local hosts.

2 Port Forwarding

Port forward01.png

  • Forwarding: map a WAN port, port range or all traffic to a local host.
    • Type: if type is "all", "source port" and "target port" shall be blank.
    • WAN: target WAN IP address.
    • Source Port: target port to the WAN interface.
    • Target IP: "redirected to" local host IP.
    • Target Port: "redirected to" port, leave it blank for same as the source port.
    • NAT Reflection: enable or disable NAT reflection.
    • Forward to VPN: When enabled, you can forward traffic to clients behind a VPN tunnel. Source IP will be translated to LAN ip address, which can be routed back via a VPN tunnel.

3 DMZ

  • DMZ: port forwarding on all ports.

Dmz01.png

4 Static NAT

  • On "WAN" zone, this rule can translate local traffic to a WAN ip address.
  • On "LAN" zone, this rule can translate internet traffic to a LAN ip address.

Nat01.png

  • Single: a single IP(192.168.10.100) or subnet(192.168.10.0/24).
  • Range: an IP range.
Personal tools
Namespaces

Variants
Actions
Navigation
Tools