Revision as of 15:48, 10 May 2018

1 Introduction

• OpenVPN is an open-source software application that implements VPN based on SSL. These two modules can setup OpenVPN tunnels in WFilter NG Firewall.
  • OpenVPN Server: provide VPN service for client to access.
  • OpenVPN Client: VPN client to connect other OpenVPN servers.

2 OpenVPN Server

2.1 Server Settings

• Auth Type: "by certificate" or "by user&pass".
  • Certificate: auth by certificate, client need to import the certificate created by the server.
  • Users & Pass: auth by user&password, only "local users" with "VPN" priviledge have VPN access.
• Protocol and port: connection protocol and port, shall be consistent with the client settings.
• Client Subnet: WFilter's openVPN works in "subnet" mode. In this mode, OpenVPN will setup a new subnet, which can not same as existing LAN subnets.
• Push Route: The subnets will be pushed to clients routing table, so client can access server's subnets. For example: route 192.168.126.0 255.255.255.0

2.2 Client Settings

• You can only create clients in "by certificate" authenticate type.
• Certificate clients can be other WFilter NGF severs or windows clients.
• "Client Subnets" defines client subnets for server to access client networks. For example: 192.168.126.0 255.255.255.0
• You need to download the client definition and import it in client side.

2.3 CA Certificate

• CA certificate: the CA certificate which shall be imported into openVPN client directory, you can click "Replace" to generate a new certificate.

3 OpenVPN Client

OpenVPN client can connect to multiple OpenVPN servers.

• Server ID：unique server ID, alphabet and numeric charactors only.
• Remote server: remote openvpn server domains or IP addresses. You can have multiple remote entries to load balance between the servers. One server per line.
• Protocol and port.
• Certificate: certificate file created in server.
• Proxy: connect to remote proxy OpenVPN server via a HTTP proxy.

4 Windows Clients

4.1 User&Pass Clients

• Download and install the offical openvpn client: https://openvpn.net/index.php/open-source/downloads.html
• Download CA certificate in WFilter NG Firewall, copy it to openvpn's config directoy with name "ca.crt".
• In config directory of openvpn, create a new text file named "myvpn.ovpn", with below content:

client
dev tun
proto udp                   #Connection protocol, same as the server settings.
remote 192.168.1.246 1194   #Server IP(domain) and port
nobind
persist-key
persist-tun
ca ca.crt                   #ca.crt filename, same directory with the myvpn.ovpn
verb 3
auth-user-pass              #auth by username

4.2 Certificate Clients

• configure file:

client
dev tun
proto udp                   #Connection protocol, same as the server settings.
remote 192.168.1.246 1194   #Server IP(domain) and port
nobind
persist-key
persist-tun
ca ca.crt                   #ca.crt filename, same directory with the myvpn.ovpn
verb 3
cert vpnuser.crt            #Exported client certificate
key vpnuser.key             #Exported client certificate key

• Now you can launch "OpenVPN GUI" with administrator privilege, input correct username and password to access VPN.

5 Firewall Rules

VPN access to LAN is controlled by firewall rules. For example, if you want to allow vpn access to all LAN clients, you need to add a firewall rule(Interface:WAN, Type: FORWARD, Action: Allow):